Thanks for the delivery and of course for the equipment itself.
The shipment went well and the test-equipment is now here and ready to be used (see picture).
First impression is very good and installation as well as first test run were successful.
Even the swiss plug has been assembled at the power cord. :-)
—— Mr. Martin Kaempf
Thanks for your e-mail!
Yes, we received the Impact hammer 2 days ago! It seems to working well ;)
If there are any further requests, by our side, we will contact you again!
—— Dirk Fleischer
Shipment and delivery went without issue. Equipment is well-constructed and professional looking.
It performs as specified.
Thank you for all of your help, it was a pleasure working with you.
—— Brian Schroeder
Dear Lily,Thanks for your mail and follow-up!Yes, the products are fine, thanks!Have a nice weekend
IEC60990 Figure 5 Measuring Network, Touch Current Weighted for Letgo-immobilization IEC 60990:2016 defines measurement methods for d.c. or a.c. current of sinusoidal or non-sinusoidal waveform, which could ... Read More
IEC 60745-2-5 Circular Saw Lower Guard Test Device, 0-30 times / min IEC 60745-2-5 clause 19.102.3 For saws having a blade with a diameter less than 210 mm, the closing time of the lower guard from the fully ... Read More
IEC60730-1 IEC Test Equipment Label Marking Abrasion Test Machine Sliding Weight 500g Production introduction: This testing apparatus is design and manufactured according to IEC60730-1 standard figure 8 and ... Read More
Spring Operated Impact Hammer for IEC60068-2-75 IEC Test Equipment Standard: IEC 60068-2-75 Environmental testing Part 2-75: Tests Test Eh: Hammer tests. IEC 60065, IEC60335-1, IEC60598-1 and etc. IEC Test ... Read More
IEC 60745-2-5 Figure 110 IEC Test Equipment Test Probe B With 12mm Diameter IEC60745-2-5 clause 18.104.22.168 For checking the accessibility of the cutting edge zone at the front of the saw above the guide plate, ... Read More
Hardened Steel IEC Test Equipment IEC 60884-1 Plug Pin Force Verification Tester Test plugs material:Hardened steel Test plugs roughness:< 0.8mm. Standard:IEC 60884-1 Fig 18 and Fig 19 Product details: This ... Read More
10 Rpm 2 Rpm IEC Test Equipment Flexion Test Apparatus For Conductors Height 250~500mm Bushing Within 15mm Standard: IEC 60947-1 ' Low-voltage switchgear and controlgear Part 1: General rules ' clause 22.214.171.124, ... Read More
IEC 60811-1-2 / ISO 188 IEC Test Equipment Aging oven 10 - 200 Product information: It is conforms to ISO 188 Rubber, vulcanized or thermoplastic Accelerated ageing and heat resistance tests, clause 8.1 of IEC ... Read More
Mechanical Material IEC Test Equipment Pressure Indentation Test Apparatus Product details: The high temperature pressure testing apparatus is used to test the heat resistance of the insulation material. It has ... Read More
Automatic IEC Test Equipment Power Cord Flexing Test Apparatus of Adjustable Bend Angle Product information: This test apparatus checks the protection of the supply cord where it enters the appliance. It ... Read More