Thanks for the delivery and of course for the equipment itself.
The shipment went well and the test-equipment is now here and ready to be used (see picture).
First impression is very good and installation as well as first test run were successful.
Even the swiss plug has been assembled at the power cord. :-)
—— Mr. Martin Kaempf
Dear Anglia,
Thanks for your e-mail!
Yes, we received the Impact hammer 2 days ago! It seems to working well ;)
If there are any further requests, by our side, we will contact you again!
—— Dirk Fleischer
Shipment and delivery went without issue. Equipment is well-constructed and professional looking.
It performs as specified.
Thank you for all of your help, it was a pleasure working with you.
—— Brian Schroeder
Dear Lily,Thanks for your mail and follow-up!Yes, the products are fine, thanks!Have a nice weekend
100 N Plug Socket Tester Device For Testing Non - Solid Pins Product overview: The appliance is checked by the test of clause 24 and, for pins which are not solid, by the following test which is made after the ... Read More
Transverse Stress Testing Device Product Introduction with Plug Socket Tester: The appliance conforms to the standard of IEC60884-1 clause 13.14 figure 13. It is suitable for checking socket which rated current ... Read More
Load weight 100N Non Solid Pin Testing Device for Plug Socket Tester Product Introduction with Plug Socket Tester: The appliance is checked by the test of IEC60884-1clause 24, figure 14, for checking pins which ... Read More
7-inch Touch Screen 3 Stastions Switch Plug Socket Endurance Tester for Plug Socket Tester Product Introduction with Plug Socket Tester: The equipment is meticulously crafted according to IEC60884-1, IEC61058-1... Read More
Four Chambers Hydrogen And Nitrogen Leak Detection System For Automobile Air Conditioning Compressor Introduction to products A four-tank hydrogen nitrogen leak detection system is a device used to detect gas ... Read More
IEC60884clause 12.14 testing equipment of Lateral Strain for socket-outlets with 5N weight Standard: IEC 60884-1 2013 clause 13.14 figure 13 Application: This device is use to check whether any damage to the ... Read More
Diameter 2.5mm Gauge For Verification Of Grooves, Holes And Reverse Tapers HC9931 Plug Socket Tester Product Introduction with Plug Socket Tester: This device conforms to the standard of IEC60884-1 clause 24.18 ... Read More
Power Cord Flexing Tester Product Introduction with Plug Socket Tester: The power cord bending test device is designed and manufactured in strict compliance with the standard requirements of IEC 60884-1 Figure ... Read More
PLC Control 3 Stastions Switch Plug Socket Endurance Tester for Plug Socket Tester Product Introduction with Plug Socket Tester: The equipment is meticulously crafted according to IEC60884-1, IEC61058-1, and ... Read More
IEC60884-1 Figure 35 Taper Gauge Product details: This device conforms to the standard of IEC60884-1 figure 35. It is used to test the groove, hole and the reverse taper. Standard: IEC 60884-1 2013 clause 24.18 ... Read More
