Thanks for the delivery and of course for the equipment itself.
The shipment went well and the test-equipment is now here and ready to be used (see picture).
First impression is very good and installation as well as first test run were successful.
Even the swiss plug has been assembled at the power cord. :-)
—— Mr. Martin Kaempf
Thanks for your e-mail!
Yes, we received the Impact hammer 2 days ago! It seems to working well ;)
If there are any further requests, by our side, we will contact you again!
—— Dirk Fleischer
Shipment and delivery went without issue. Equipment is well-constructed and professional looking.
It performs as specified.
Thank you for all of your help, it was a pleasure working with you.
—— Brian Schroeder
Dear Lily,Thanks for your mail and follow-up!Yes, the products are fine, thanks!Have a nice weekend
Length 100mm Diameter 1mm - Test Probe D With 1 N Force Scale Display IEC60529 The 1mm test rod meets IEC61032 figure 4 test probe D and EN Standards including IEC60529 for IP4 and suffix D codes. It is used to ... Read More
IEC62151 Figure 3 - Test Probe - Length 80mm Diameter 12mm - For Information Technology Equipment IEC62151 clause 220.127.116.11 Accessibility The equipment shall be so constructed that in USER ACCESS AREAS there is ... Read More
IEC60529-1 Test Finger Probe Test Finger Probe B With Force Of 10N , 20N , 30N Standard: IEC 61032 figure 2, IEC60950 figure 2A, IEC60884, IEC60335, UL507, and UL1278 figure 8.4. Application: This probe is ... Read More
Scratching Tool Tip Test Finger Probe Scratch Pin Probe IEC60335-2-24 Figure 102 Standard:Conforms to IEC60335-2-24 Clause 22.107.2 figure 102. Application:The scratch pin probe use to do the scratch test with ... Read More
IEC60335-2-24 clause 22.116 Test Finger Probe Centre Punch For Accessible Glass Panels Test Standard: The center punch is manufacture according to IEC60335-2-24 clause 22.116, IEC 60598-2-3 clause3.6.5 and etc. ... Read More
Diameter 50mm Test Probe A Made Of Stainless Steel And Nylon, Accord With IEC60529 IP1 Product introduction: This probe made of stainless steel and nylon, the sphere made of stainless steel, the baffle and ... Read More
UL1278 Figure 8.4 Articulate Probe Test Probe B - Verify Accessibility of Live Parts Product information: An electrical part of a heater shall be so located or enclosed that protection against unintentional ... Read More
IEC 60065 Test Probe C 2.5mm Diameter 100mm Length for HAZARDOUS LIVE TEST IEC60065-2014 Clause 9.1 .5 Pre-set controls If a hole giving access to pre-set controls is marked as such on the enclosure or in the ... Read More
IEC 60065 Test Probe D 1mm Diameter 100mm Length for HAZARDOUS LIVE TEST IEC60065 Clause 9.1 .4 TERMINALS The use of a single-pole plug or a bare wire to make connection with a contact of a TERMINAL for earth ... Read More
ISO 20653 Test Finger Probe Test Probe 2 - 12.5mm steel ball Tolerance 0.05mm Standard:ISO 20653, IEC61032 figure 6 probe 2,IEC60529 of IP2. Application:It is intended to verify the degree of protection of ... Read More